Greenhouse Splicing Insect Net Cover — Model 002 Thickened Full-Specification (Vegetables & Fruit)

Greenhouse tunnels rarely match roll widths, and that mismatch is where insect netting fails: a 6 m arch covered with three 2 m panels is only as good as the seams between them. Model 002 is a thickened HDPE net built for splicing — panels join edge-to-edge so standard rolls cover any arch width.

Built to Be Seamed

• Thickened monofilament — seams take the highest tension on a covered tunnel; heavier twine holds the overlap without tearing at the stitch line
• Full-specification splicing — standard panels join into 4 m, 6 m or 8 m+ coverage
• UV-stabilized HDPE — stays supple a full season; folds do not crack like unstabilized film
• Dense weave — blocks aphids, whiteflies and fruit flies that slip through seam gaps
• Rope-and-clip install — reinforced edge threads over hoops; no specialist tools

📋 Product Specifications

Seam Placement Matters More Than You Think

A spliced cover protects only as well as its weakest seam:

• Run seams along the ridge, not the sides — side seams take wind load and pull apart
• Overlap, never butt-join — a 10 cm overlap gives fastenings something to bite
• Set the net before the crop flowers — re-fitting after fruit set is expensive

For non-standard hoops or long tunnels, send the arch width and ridge height — we pre-cut the panels.

Factory-direct from Shandong, China · MOQ 100 pcs · Pre-cut splicing panels to your arch dimensions · Request a wholesale quote →